How We Work

At Central Coast Concrete Cutting and Demolition, we approach every project with safety, precision, and full compliance in mind. Serving all of San Luis Obispo County, we ensure that each job is completed in accordance with local construction codes, environmental guidelines, and safety standards.

We start by discussing your project goals—whether it’s slab removal, trench cutting, or core drilling. Then we schedule an on-site evaluation to assess:

• The type and thickness of concrete
   
• Exact cut locations (floor, wall, slab, exterior, interior)
   
• Access to utilities (electricity, water)
   
• Job site safety and environmental considerations
   
• Any required permits or notification procedures in line with SLO County laws
   

You'll receive a detailed quote, timeline, and scope of work tailored to your specific site.

Our team arrives fully equipped with cutting tools, safety gear, and containment systems. We:

• Clearly mark cut lines
   
• Protect adjacent structures and surfaces
   
• Set up water suppression systems to reduce airborne dust (as required by SLO County Air Pollution Control District regulations)
   
• Ensure site safety through proper signage, PPE, and barricades
   

We also confirm that utility lines are properly located before work begins, per county safety requirements.

Depending on your project, we perform:

• Flat Sawing for driveways, concrete pads, and trench lines
   
• Core Drilling for plumbing, HVAC, and electrical systems
   
• Wall Sawing for precise vertical or horizontal cuts in concrete or masonry
   
• Controlled Demolition and section removal as needed
   

All cutting is performed by trained professionals using industry-standard techniques, while minimizing vibration and disruption to surrounding structures.

Once cutting is complete:

• We remove all concrete debris and waste according to San Luis Obispo County disposal guidelines
   
• Clean the workspace thoroughly, including wet slurry containment if applicable
   
• Ensure the site is safe and clear for follow-up trades or project phases
   

We check in to confirm the job meets your expectations and remains compliant with county codes. We’re always available to answer follow-up questions or assist with additional cutting needs.